[RFC Home] [TEXT|PDF|HTML] [Tracker] [IPR] [Info page]

PROPOSED STANDARD
Network Working Group                                        K. Fujisawa
Request for Comments: 2855                              Sony Corporation
Category: Standards Track                                      June 2000


                           DHCP for IEEE 1394

Status of this Memo

   This document specifies an Internet standards track protocol for the
   Internet community, and requests discussion and suggestions for
   improvements.  Please refer to the current edition of the "Internet
   Official Protocol Standards" (STD 1) for the standardization state
   and status of this protocol.  Distribution of this memo is unlimited.

Copyright Notice

   Copyright (C) The Internet Society (2000).  All Rights Reserved.

Abstract

   IEEE Std 1394-1995 is a standard for a High Performance Serial Bus.
   Since 1394 uses a different link-layer addressing method than
   conventional IEEE802/Ethernet, the usage of some fields must be
   clarified to achieve interoperability.  This memo describes the 1394
   specific usage of some fields of DHCP messages.

1. Introduction

   IEEE Std 1394-1995 is a standard for a High Performance Serial Bus.
   IETF IP1394 Working Group specified the method to carry IPv4
   datagrams and 1394 ARP packets over an IEEE1394 network [RFC2734].

   The Dynamic Host Configuration Protocol (DHCP) [RFC2131] provides a
   framework for passing configuration information to hosts on a TCP/IP
   network.

   Since 1394 uses a different link-layer addressing method than
   conventional IEEE802/Ethernet, the usage of some fields must be
   clarified to achieve interoperability.  This memo describes the 1394
   specific usage of some fields of DHCP.  See [RFC2131] for the
   mechanism of DHCP and the explanations of each field.

   The key words "MUST", "MUST NOT", "REQUIRED", "SHALL", "SHALL NOT",
   "SHOULD", "SHOULD NOT", "RECOMMENDED",  "MAY", and "OPTIONAL" in this
   document are to be interpreted as described in RFC 2119 [RFC2119].





Fujisawa                    Standards Track                     [Page 1]


RFC 2855                   DHCP for IEEE 1394                  June 2000


2. Issues related to 1394 link address

   With conventional link-layer protocols, such as an Ethernet, the
   'chaddr' (client hardware address) field may be used to return a
   reply message from a DHCP server (or relay-agent) to a client.  Since
   a 1394 link address (node_ID) is transient and will not be consistent
   across the 1394 bridge, we have chosen not to put it in the 'chaddr'
   field.  A DHCP client should request that the server sends a
   broadcast reply by setting the BROADCAST flag when 1394 ARP is not
   possible yet.

      Note: In general, the use of a broadcast reply is discouraged, but
      we consider the impact in a 1394 network as a non issue.

3. 1394 specific usage of DHCP message fields

   Following rules should be used when a DHCP client is connected to an
   IEEE1394 network.

   'htype' (hardware address type) MUST be 24 [ARPPARAM].

   'hlen' (hardware address length) MUST be 0.

   The 'chaddr' (client hardware address) field is reserved.  The sender
   MUST set this field to zero, and the recipient and the relay agent
   MUST ignore its value on receipt.

   A DHCP client on 1394 SHOULD set a BROADCAST flag in DHCPDISCOVER and
   DHCPREQUEST messages (and set 'ciaddr' to zero) to ensure that the
   server (or the relay agent) broadcasts its reply to the client.

      Note: As described in [RFC2131], 'ciaddr' MUST be filled in with
      client's IP address during BOUND, RENEWING or REBINDING state,
      therefore, the BROADCAST flag MUST NOT be set.  In these cases,
      the DHCP server unicasts DHCPACK message to the address in
      'ciaddr'. The link address will be resolved by 1394 ARP.

   'client identifier' option MUST be used in DHCP messages from the
   client to the server due to the lack of the 'chaddr'.  'client
   identifier' option may consist of any data.  Because every IP over
   1394 node has an EUI-64 (node unique ID), the EUI-64 makes an obvious
   'client identifier'.  1394 clients SHOULD include an EUI-64
   identifier in the 'client identifier' option. The type value for the
   EUI-64 is 27 [ARPPARAM], and the format is illustrated as follows.







Fujisawa                    Standards Track                     [Page 2]


RFC 2855                   DHCP for IEEE 1394                  June 2000


    Code  Len   Type  Client-Identifier
   +-----+-----+-----+-----+-----+-----+-----+-----+-----+-----+-----+
   |  61 |  9  | 27  |           EUI-64 (node unique ID)             |
   +-----+-----+-----+-----+-----+-----+-----+-----+-----+-----+-----+

   Note that the use of other 'client identifier' type, such as a fully
   qualified domain name (FQDN), is not precluded by this memo.

   For more details, see "9.14. Client-identifier" in [RFC2132].

4. Security Considerations

   DHCP currently provides no authentication or security mechanisms.
   Potential exposures to attack are discussed in section 7 of the DHCP
   protocol specification [RFC2131].

   A malicious client can falsify its EUI-64 identifier, thus
   masquerading as another client.

Acknowledgments

   The author appreciates the members of the Dynamic Host Configuration
   Working Group for their review and valuable comments.

References

   [RFC2734]  Johansson, P., "IPv4 over IEEE 1394", RFC 2734, December
              1999.

   [RFC2119]  Bradner, S., "Key words for use in RFCs to Indicate
              Requirement Levels", RFC 2119, March 1997.

   [RFC2131]  Droms, R., "Dynamic Host Configuration Protocol", RFC
              2131, March 1997.

   [RFC2132]  Alexander, S. and R. Droms, "DHCP Options and BOOTP Vendor
              Extensions", RFC 2132, March 1997.

   [ARPPARAM] http://www.iana.org/numbers.html












Fujisawa                    Standards Track                     [Page 3]


RFC 2855                   DHCP for IEEE 1394                  June 2000


Author's Address

   Kenji Fujisawa
   Sony Corporation
   6-7-35, Kitashinagawa,
   Shinagawa-ku, Tokyo, 141-0001 Japan

   Phone: +81-3-5448-8507
   EMail: fujisawa@sm.sony.co.jp










































Fujisawa                    Standards Track                     [Page 4]


RFC 2855                   DHCP for IEEE 1394                  June 2000


Full Copyright Statement

   Copyright (C) The Internet Society (2000).  All Rights Reserved.

   This document and translations of it may be copied and furnished to
   others, and derivative works that comment on or otherwise explain it
   or assist in its implementation may be prepared, copied, published
   and distributed, in whole or in part, without restriction of any
   kind, provided that the above copyright notice and this paragraph are
   included on all such copies and derivative works.  However, this
   document itself may not be modified in any way, such as by removing
   the copyright notice or references to the Internet Society or other
   Internet organizations, except as needed for the purpose of
   developing Internet standards in which case the procedures for
   copyrights defined in the Internet Standards process must be
   followed, or as required to translate it into languages other than
   English.

   The limited permissions granted above are perpetual and will not be
   revoked by the Internet Society or its successors or assigns.

   This document and the information contained herein is provided on an
   "AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING
   TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
   BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION
   HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF
   MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

Acknowledgement

   Funding for the RFC Editor function is currently provided by the
   Internet Society.



















Fujisawa                    Standards Track                     [Page 5]