[RFC Home] [TEXT|PDF|HTML] [Tracker] [IPR] [Info page]

PROPOSED STANDARD
Network Working Group                                            M. Rose
Request for Comments: 3081                        Invisible Worlds, Inc.
Category: Standards Track                                     March 2001


                     Mapping the BEEP Core onto TCP

Status of this Memo

   This document specifies an Internet standards track protocol for the
   Internet community, and requests discussion and suggestions for
   improvements.  Please refer to the current edition of the "Internet
   Official Protocol Standards" (STD 1) for the standardization state
   and status of this protocol.  Distribution of this memo is unlimited.

Copyright Notice

   Copyright (C) The Internet Society (2001).  All Rights Reserved.

Abstract

   This memo describes how a BEEP (Blocks Extensible Exchange Protocol)
   session is mapped onto a single TCP (Transmission Control Protocol)
   connection.

Table of Contents

   1.    Introduction . . . . . . . . . . . . . . . . . . . . . . . . 1
   2.    Session Management . . . . . . . . . . . . . . . . . . . . . 2
   3.    Message Exchange . . . . . . . . . . . . . . . . . . . . . . 2
   3.1   Flow Control . . . . . . . . . . . . . . . . . . . . . . . . 3
   3.1.1 Channel Creation . . . . . . . . . . . . . . . . . . . . . . 3
   3.1.2 Sending Messages . . . . . . . . . . . . . . . . . . . . . . 3
   3.1.3 Processing SEQ Frames  . . . . . . . . . . . . . . . . . . . 4
   3.1.4 Use of Flow Control  . . . . . . . . . . . . . . . . . . . . 4
   4.    Security Considerations  . . . . . . . . . . . . . . . . . . 6
         References . . . . . . . . . . . . . . . . . . . . . . . . . 6
         Author's Address . . . . . . . . . . . . . . . . . . . . . . 6
   A.    Acknowledgements . . . . . . . . . . . . . . . . . . . . . . 7
         Full Copyright Statement . . . . . . . . . . . . . . . . . . 8

1. Introduction

   This memo describes how a BEEP [1] session is mapped onto a single
   TCP [2] connection.  Refer to Section 2.5 of [1] for an explanation
   of the mapping requirements.





Rose                        Standards Track                     [Page 1]


RFC 3081             Mapping the BEEP Core onto TCP           March 2001


2. Session Management

   The mapping of BEEP session management onto the TCP service is
   straight-forward.

   A BEEP session is established when a TCP connection is established
   between two BEEP peers:

   o  the BEEP peer that issues a passive TCP OPEN call is termed the
      listener; and,

   o  the BEEP peer that issues an active TCP OPEN call is termed the
      initiator.

   A simultaneous TCP OPEN would result in both BEEP peers believing
   they are the initiator and neither peer will be able to start any
   channels.  Because of this, services based on BEEP must be designed
   so that simultaneous TCP OPENs cannot occur.

   If both peers agree to release a BEEP session (c.f., [1]'s Section
   2.4), the peer sending the "ok" reply, immediately issues the TCP
   CLOSE call.  Upon receiving the reply, the other peer immediately
   issues the TCP CLOSE call.

   A BEEP session is terminated when either peer issues the TCP ABORT
   call, and the TCP connection is subsequently aborted.

3. Message Exchange

   The mapping of BEEP exchanges onto the TCP service is less straight-
   forward.

   Messages are reliably sent and received using TCP's SEND and RECEIVE
   calls.  (This also provides ordered delivery of messages on the same
   channel.)

   Although TCP imposes flow control on a per-connection basis, if
   multiple channels are simultaneously in use on a BEEP session, BEEP
   must provide a mechanism to avoid starvation and deadlock.  To
   achieve this, BEEP re-introduces a mechanism used by the TCP:
   window-based flow control -- each channel has a sliding window that
   indicates the number of payload octets that a peer may transmit
   before receiving further permission.








Rose                        Standards Track                     [Page 2]


RFC 3081             Mapping the BEEP Core onto TCP           March 2001


3.1 Flow Control

   Recall from Section 2.2.1.2 of [1] that every payload octet sent in
   each direction on a channel has an associated sequence number.
   Numbering of payload octets within a data frame is such that the
   first payload octet is the lowest numbered, and the following payload
   octets are numbered consecutively.

   The actual sequence number space is finite, though very large,
   ranging from 0..4294967295 (2**32 - 1).  Since the space is finite,
   all arithmetic dealing with sequence numbers is performed modulo
   2**32.  This unsigned arithmetic preserves the relationship of
   sequence numbers as they cycle from 2**32 - 1 to 0 again.  Consult
   Sections 2 through 5 of [3] for a discussion of the arithmetic
   properties of sequence numbers.

3.1.1 Channel Creation

   When a channel is created, the sequence number associated with the
   first payload octet of the first data frame is 0, and the initial
   window size for that channel is 4096 octets.  After channel creation,
   a BEEP peer may update the window size by sending a SEQ frame
   (Section 3.1.3).

   If a BEEP peer is asked to create a channel and it is unable to
   allocate at least 4096 octets for that channel, it must decline
   creation of the channel, as specified in Section 2.3.1.2 of [1].
   Similarly, during establishment of the BEEP session, if the BEEP peer
   acting in the listening role is unable to allocate at least 4096
   octets for channel 0, then it must return a negative reply, as
   specified in Section 2.4 of [1], instead of a greeting.

3.1.2 Sending Messages

   Before a message is sent, the sending BEEP peer must ensure that the
   size of the payload is within the window advertised by the receiving
   BEEP peer.  If not, it has three choices:

   o  if the window would allow for at least one payload octet to be
      sent, the BEEP peer may segment the message and start by sending a
      smaller data frame (up to the size of the remaining window);

   o  the BEEP peer may delay sending the message until the window
      becomes larger; or,







Rose                        Standards Track                     [Page 3]


RFC 3081             Mapping the BEEP Core onto TCP           March 2001


   o  the BEEP peer may signal to its application that it is unable to
      send the message, allowing the application to try again at a later
      time (or perhaps signaling its application when a larger window is
      available).

   The choice is implementation-dependent, although it is recommended
   that the application using BEEP be given a mechanism for influencing
   the decision.

3.1.3 Processing SEQ Frames

   As an application accepts responsibility for incoming data frames,
   its BEEP peer should send SEQ frames to advertise a new window.

   The ABNF [4] for a SEQ frame is:

      seq        = "SEQ" SP channel SP ackno SP window CR LF

      ackno      = seqno

      window     = size

      ; channel, seqno, and size are defined in Section 2.2.1 of [1].

   The SEQ frame has three parameters:

   o  a channel number;

   o  an acknowledgement number, that indicates the value of the next
      sequence number that the sender is expecting to receive on this
      channel; and,

   o  a window size, that indicates the number of payload octets
      beginning with the one indicated by the acknowledgement number
      that the sender is expecting to receive on this channel.

   A single space character (decimal code 32, " ") separates each
   component.  The SEQ frame is terminated with a CRLF pair.

   When a SEQ frame is received, if any of the channel number,
   acknowledgement number, or window size cannot be determined or is
   invalid, then the BEEP session is terminated without generating a
   response, and it is recommended that a diagnostic entry be logged.

3.1.4 Use of Flow Control

   The key to successful use of flow control within BEEP is to balance
   performance and fairness:



Rose                        Standards Track                     [Page 4]


RFC 3081             Mapping the BEEP Core onto TCP           March 2001


   o  large messages should be segmented into frames no larger than
      two-thirds of TCP's negotiated maximum segment size;

   o  frames for different channels with traffic ready to send should be
      sent in a round-robin fashion;

   o  each time a frame is received, a SEQ frame should be sent whenever
      the window size that will be sent is at least one half of the
      buffer space available to this channel; and,

   o  if the transport service presents multiple frames to a BEEP peer
      simultaneously, then a single consolidating SEQ frame may be sent.

   In order to avoid pathological interactions with the transport
   service, it is important that a BEEP peer advertise windows based on
   available buffer space, to allow data to be read from the transport
   service as soon as available.  Further, SEQ frames for a channel must
   have higher priority than messages for that channel.

   Implementations may wish to provide queue management facilities to
   the application using BEEP, e.g., channel priorities, (relative)
   buffer allocations, and so on.  In particular, implementations should
   not allow a given channel to monopolize the underlying transport
   window (e.g., slow readers should get small windows).

   In addition, where possible, implementations should support transport
   layer APIs that convey congestion information.  These APIs allow an
   implementation to determine its share of the available bandwidth, and
   also be notified of changes in the estimated path bandwidth.  Note
   that when a BEEP session has multiple channels that are
   simultaneously exchanging large messages, implementations without
   access to this information may have uncertain fairness and progress
   properties during times of network congestion.

   Finally, implementors should follow the guidelines given in the
   relevant portions of RFC1122 [5] that deal with flow control (and
   bear in mind that issues such as retransmission, while they interact
   with flow control in TCP, are not applicable to this memo).  For
   example, Section 4.2.2.16 of RFC1122 [5] indicates that a "receiver
   SHOULD NOT shrink the window, i.e., move the right window edge to the
   left" and then discusses the impact of this rule on unacknowledged
   data.  In the context of mapping BEEP onto a single TCP connection,
   only the portions concerning flow control should be implemented.








Rose                        Standards Track                     [Page 5]


RFC 3081             Mapping the BEEP Core onto TCP           March 2001


4. Security Considerations

   Consult Section [1]'s Section 9 for a discussion of security issues.

References

   [1]  Rose, M., "The Blocks Extensible Exchange Protocol Core", RFC
        3080, March 2001.

   [2]  Postel, J., "Transmission Control Protocol", STD 7, RFC 793,
        September 1981.

   [3]  Elz, R. and R. Bush, "Serial Number Arithmetic", RFC 1982,
        August 1996.

   [4]  Crocker, D. and P. Overell, "Augmented BNF for Syntax
        Specifications: ABNF", RFC 2234, November 1997.

   [5]  Braden, R., "Requirements for Internet Hosts -- Communication
        Layers", STD 3, RFC 1122, October 1989.

Author's Address

   Marshall T. Rose
   Invisible Worlds, Inc.
   1179 North McDowell Boulevard
   Petaluma, CA  94954-6559
   US

   Phone: +1 707 789 3700
   EMail: mrose@invisible.net
   URI:   http://invisible.net/



















Rose                        Standards Track                     [Page 6]


RFC 3081             Mapping the BEEP Core onto TCP           March 2001


Appendix A. Acknowledgements

   The author gratefully acknowledges the contributions of: Dave
   Crocker, Steve Harris, Eliot Lear, Keith McCloghrie, Craig Partridge,
   Vernon Schryver, and, Joe Touch.  In particular, Dave Crocker
   provided helpful suggestions on the nature of flow control in the
   mapping.












































Rose                        Standards Track                     [Page 7]


RFC 3081             Mapping the BEEP Core onto TCP           March 2001


Full Copyright Statement

   Copyright (C) The Internet Society (2001).  All Rights Reserved.

   This document and translations of it may be copied and furnished to
   others, and derivative works that comment on or otherwise explain it
   or assist in its implementation may be prepared, copied, published
   and distributed, in whole or in part, without restriction of any
   kind, provided that the above copyright notice and this paragraph are
   included on all such copies and derivative works.  However, this
   document itself may not be modified in any way, such as by removing
   the copyright notice or references to the Internet Society or other
   Internet organizations, except as needed for the purpose of
   developing Internet standards in which case the procedures for
   copyrights defined in the Internet Standards process must be
   followed, or as required to translate it into languages other than
   English.

   The limited permissions granted above are perpetual and will not be
   revoked by the Internet Society or its successors or assigns.

   This document and the information contained herein is provided on an
   "AS IS" basis and THE INTERNET SOCIETY AND THE INTERNET ENGINEERING
   TASK FORCE DISCLAIMS ALL WARRANTIES, EXPRESS OR IMPLIED, INCLUDING
   BUT NOT LIMITED TO ANY WARRANTY THAT THE USE OF THE INFORMATION
   HEREIN WILL NOT INFRINGE ANY RIGHTS OR ANY IMPLIED WARRANTIES OF
   MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.

Acknowledgement

   Funding for the RFC Editor function is currently provided by the
   Internet Society.



















Rose                        Standards Track                     [Page 8]