RFC 5036, "LDP Specification", October 2007Source of RFC: mpls (rtg)
Errata ID: 4465
Publication Format(s) : TEXT
Reported By: Guijuan Wang
Date Reported: 2015-09-05
Rejected by: Deborah Brungard
Date Rejected: 2015-11-18
Section 3.5.3 says:
The first rule: In section 3.5.3 A, Label Advertisement Discipline [omitting the first paragraph] If one LSR proposes Downstream Unsolicited and the other proposes Downstream on Demand, the rules for resolving this difference is: - If the session is for a label-controlled ATM link or a label-controlled Frame Relay link, then Downstream on Demand MUST be used. - Otherwise, Downstream Unsolicited MUST be used. The second rule: In section 188.8.131.52.3. In general, the upstream LSR is responsible for requesting label mappings when operating in Downstream on Demand mode. However, unless some rules are followed, it is possible for neighboring LSRs with different advertisement modes to get into a livelock situation where everything is functioning properly, but no labels are distributed. For example, consider two LSRs Ru and Rd where Ru is the upstream LSR and Rd is the downstream LSR for a particular FEC. In this example, Ru is using Downstream Unsolicited advertisement mode and Rd is using Downstream on Demand mode. In this case, Rd may assume that Ru will request a label mapping when it wants one and Ru may assume that Rd will advertise a label if it wants Ru to use one. If Rd and Ru operate as suggested, no labels will be distributed from Rd to Ru. This livelock situation can be avoided if the following rule is observed: an LSR operating in Downstream on Demand mode SHOULD NOT be expected to send unsolicited mapping advertisements. Therefore, if the downstream LSR is operating in Downstream on Demand mode, the upstream LSR is responsible for requesting label mappings as needed.
It should say:
Label advertisement mode negotiation rule is different in two sections.
when the label advertisement mode is different between LSR peers,
the resolving rule is defined twice in two chapters,
both use "must" or "SHOULD NOT", but they are completely different.
It's better to settle down which rule to use for this case.
Seems the first one is simpler for implementation.
Or if you want to keep both rules,
better to enumerate both of those two rules in each section,
and say the implementer can choose any of them.
This suggested errata requires an update to the RFC, which requires consensus.