errata logo graphic

Found 3 records.

Status: Verified (1)

RFC2327, "SDP: Session Description Protocol", April 1998

Note: This RFC has been obsoleted by RFC4566

Source of RFC: mmusic (rai)

Errata ID: 459

Status: Verified
Type: Technical

Reported By: Not recorded
Date Reported: 2000-12-31

In the document, the following characters should be replaced with corrected text.

       '|' should be  '/'
       '"""' and '"' should be 'DQUOTE'
       '0x01..0x09'  should be '%x01-09'

Notes:

The date reported was not recorded. The estimate is during 2000.


Status: Held for Document Update (2)

RFC2327, "SDP: Session Description Protocol", April 1998

Note: This RFC has been obsoleted by RFC4566

Source of RFC: mmusic (rai)

Errata ID: 458

Status: Held for Document Update
Type: Editorial

Reported By: Richard Walters
Date Reported: 2005-08-01
Held for Document Update by: Robert Sparks

Section 6 says:

      An example of a static payload type is u-law PCM coded single
      channel audio sampled at 8KHz.  This is completely defined in the
      RTP Audio/Video profile as payload type 0, so the media field for
      such a stream sent to UDP port 49232 is:

                            m=video 49232 RTP/AVP 0

      An example of a dynamic payload type is 16 bit linear encoded
      stereo audio sampled at 16KHz.  If we wish to use dynamic RTP/AVP
      payload type 98 for such a stream, additional information is
      required to decode it:

                           m=video 49232 RTP/AVP 98

It should say:

      An example of a static payload type is u-law PCM coded single
      channel audio sampled at 8KHz.  This is completely defined in the
      RTP Audio/Video profile as payload type 0, so the media field for
      such a stream sent to UDP port 49232 is:

                            m=audio 49232 RTP/AVP 0

      An example of a dynamic payload type is 16 bit linear encoded
      stereo audio sampled at 16KHz.  If we wish to use dynamic RTP/AVP
      payload type 98 for such a stream, additional information is
      required to decode it:

                           m=audio 49232 RTP/AVP 98

Notes:

The examples refer to audio but show the media type as "video". I believe
the author intended to put "m=audio" but "m=video" was put in by mistake.


Errata ID: 1093

Status: Held for Document Update
Type: Editorial

Reported By: Jim Bell
Date Reported: 2007-12-17
Held for Document Update by: Robert Sparks

Section 6 says:

The following unit specification characters are allowed:

                         d - days (86400 seconds)
                        h - minutes (3600 seconds)
                         m - minutes (60 seconds)

It should say:

The following unit specification characters are allowed:

                         d - days (86400 seconds)
                        h - hours (3600 seconds)
                         m - minutes (60 seconds)

Notes:

I believe the author means "h" for "hours" and "m" for "minutes" unambiguously.


Report New Errata